AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Furnace Repair Across Clovis
Clovis AC Repair and furnace work typically costs $150 to $700, and most jobs are done same day when you call before noon. We dispatch technicians directly to Clovis neighborhoods from our office in the Central Valley, so we’re not driving from across the metro when your heat fails on a 38-degree February morning. Call (559) 354-6878 and you’ll get a live person, not a phone tree.
Clovis homeowners know that winter nights dip colder than people expect. The same hot, dry air that bakes rooftops in August means attics in Old Town Clovis and along Willow Avenue can swing from 120°F in summer to near-freezing in winter. That stress cycle is hard on furnace ignition systems, blower motors, and control boards. We plan repairs around that reality, not around a generic service manual.
Why Brandt HVAC Co Fresno Is Clovis’s Preferred Furnace Repair Company
We’ve been repairing furnaces in Clovis long enough to know that the city’s housing stock has a specific character. Tract homes built from the 1980s onward dominate the neighborhoods around Sierra Vista, Tarpey Village, and the newer subdivisions east of Locan Avenue. Many still run their original builder-grade furnaces. When those units fail, they fail in predictable ways: cracked heat exchangers from short-cycling, failing blower motors after fifteen years of dust and dry air, and ignition problems tied to brittle wiring in hot attics.
Devin Marlowe runs our repair operation with a straightforward rule: name the problem, write the price, prove your identity at the door. That’s the Threshold Verified standard. Every technician who shows up in Clovis has been background-checked and identity-verified. You’ll get their name and photo before the visit, and they’ll show you a photo ID badge when they arrive. If someone shows up you weren’t told to expect, the visit is on us.
We answer the phone 24/7. A live person picks up at 3 a.m. when your furnace quits and your house is dropping below 50 degrees. No voicemail queue. No automated menu. That matters in Clovis because cold snaps here are short but sharp. A furnace that dies on a 35-degree night needs a responder, not a callback.
Our Furnace Repair team stocks common parts for Lennox, Goodman, Rheem, and York systems, so we’re not waiting two days on a warehouse order when your ignitor fails during the first hard freeze. Most Clovis repairs are completed in one visit.
Styles & brands we work with
Heat Pump Repair in Clovis
Heat Pump Repair in Clovis requires a technician who understands that these systems work double duty: cooling through 100°F-plus summers and heating through the mild but real winter cold snaps. When a heat pump quits heating, the culprit is usually a failed reversing valve, a faulty defrost sensor, or low refrigerant charge that starves the coils. In Clovis, we also see capacitor failures from the long summer run hours, which then surface as no-heat complaints in December when the system finally shifts modes.
Reversing Valve and Defrost Issues
The reversing valve is what flips a heat pump from cooling to heating. When it sticks, the system may blow cold air in heat mode or run constantly without reaching setpoint. In Clovis, a stuck reversing valve often shows up on the first genuinely cold morning, not during the mild daytime. A typical heat pump repair in this category runs $150 – $700 depending on whether we’re replacing a sensor, a coil component, or the valve itself.
Capacitor and Electrical Failures
Clovis summers run heat pump compressors hard for six months straight. Capacitors degrade. When winter comes and the compressor needs to start against cold refrigerant, a weak capacitor can’t get it going. We test electrical components during Clovis heat pump calls as a matter of course because a failed start capacitor is far cheaper to replace than a burned-out compressor.
Heating Repair in Clovis
Heating Repair in Clovis covers both furnace systems and heat pump heating modes. The common denominator is deferred maintenance. Clovis winters are mild enough that most homeowners don’t think about their heating system until it fails. Then the first cold snap hits, the furnace tries to run after months of sitting in a dusty attic, and something gives. We see blower motor failures, dirty flame sensors that won’t prove flame, and cracked heat exchangers from years of short-cycling on undersized ductwork.
Blower Motor and Airflow Repairs
A blower motor that starts making a whining noise or stops entirely often traces back to dust and dryness. Clovis attics are particularly dusty. Fine grit works into motor bearings and wears them out. Replacing a blower motor on a typical Clovis furnace runs $150 – $700 parts and labor, depending on the motor type (single-speed, multi-speed, or ECM). We check static pressure before and after the swap; a new motor won’t fix airflow if the ducts are the real problem.
Ignition System Repairs
Furnaces with electronic ignition use a hot surface ignitor that glows red-hot to light the burners. These ignitors are fragile and fail with age. In Clovis’s dry climate, they also crack from thermal shock when a furnace cycles on and off repeatedly during shoulder-season weather. Ignitor replacement is one of our most common one-visit fixes, usually at the lower end of the repair range.
Trusted Brands We Service in Clovis
We service all major residential HVAC brands, but in Clovis we see a lot of Goodman, Rheem, York, and Lennox equipment from the tract-building waves of the 1990s and 2000s, plus plenty of systems that need Clovis Trane service. Our techs carry common replacement parts for these units: ignitors, flame sensors, capacitors, pressure switches, blower motors, and control boards. That local parts stock means fewer return trips and faster repairs for Clovis homeowners. If your furnace is a less common brand, we can usually source parts within one business day from regional suppliers.
Common Furnace Repair Problems We See in Clovis Homes
- Heat-damaged flex duct in 120°F+ attics. East-side tract homes built since the 1990s often have original flex duct runs that sag, kink, or collapse under years of extreme attic heat. The furnace works fine, but airflow to back bedrooms dies.
- Short-cycling from undersized systems. Many single-zone 3-ton systems in Clovis were sized for a smaller house or an uninsulated attic. When rooms get added or insulation changes, the furnace overheats and trips the limit switch.
- Capacitor failures on the first cold snap. Furnaces that sit idle through Clovis’s long hot season often fail to start when cold weather finally arrives. Weak capacitors are the usual suspect.
- Cracked heat exchangers from repeated overheating. When ducts are collapsed or undersized, the heat exchanger can’t shed heat properly. It expands, contracts, and eventually cracks. This is a serious safety issue and a mandatory repair.
See the difference
Before
After
Before
After
Before
AfterPricing for Furnace Repair in Clovis, CA
A furnace repair in Clovis runs $150 – $700 for most jobs. Ignitor replacement typically lands at the low end ($150 – $300). Blower motors, control boards, gas valves, and heat exchanger repairs run higher, usually $350 – $700. You’ll always get a written price before any work starts, and that price doesn’t change unless we find something genuinely new and you approve the additional cost in writing first. We don’t do surprise invoices. A furnace tune-up in Clovis runs $80 – $200 and is the cheapest insurance against a cold-weather breakdown.
Call (559) 354-6878 for a free estimate. We’ll give you real numbers over the phone or in person, whichever you prefer.
| Service | Typical Clovis Price Range |
|---|---|
| Furnace Repair | $150 – $700 |
| Heat Pump Repair | $150 – $700 |
| Furnace Tune-Up | $80 – $200 |
The East-Side Clovis Duct Problem
Clovis’s east-side tract homes built since the 1990s often have original 3-ton split systems with flex duct in 120°F+ attics, so furnace repair here frequently uncovers heat-damaged ductwork that undermines heating performance even after the unit is fixed. Homeowners in neighborhoods around the Clovis Unified School District boundary call us for a furnace that won’t heat the back bedrooms, and we find the blower motor working fine while crushed, brittle return ducts starve the system. This isn’t a brand issue. It’s a housing-stock issue specific to how fast Clovis grew and what builders put in those attics.
We diagnosed a furnace short-cycling in a Clovis Unified boundary neighborhood where the original flex duct had collapsed in the attic heat. After replacing the blower motor and resetting the thermostat calibration, we measured static pressure and found the real culprit was crushed returns, so we repaired the duct and reduced the tonnage mismatch before the heat exchanger cracked. That’s the kind of repair you only catch if you’re looking past the obvious part failure and measuring what the whole system is doing.
In Clovis, a like-for-like furnace swap often disappoints. If the original unit never heated evenly, replacing it with the same size simply rebuilds the same failure mode with newer parts. The problem is rarely the furnace itself. It’s the ductwork, the airflow, and the mismatch between the system and the floor plan. We check static pressure, measure room-by-room airflow, and tell you plainly whether you need a repair or a redesigned fix. That’s what the 365-Day Done Right Promise means: if we fix it and it’s not right, we come back at no charge.
We Also Serve Cities Near Clovis
Our technicians regularly drive between Clovis and the surrounding Central Valley cities, including Fresno, Sanger, Fowler, and Madera. If you’re in Furnace Repair in Clovis or just outside, call (559) 354-6878 and ask about same-day availability for your area.
Serving Clovis, CA - Our Local Coverage Area
We’re based in the Clovis area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Clovis
Because the thermostat was never the problem. In east-side Clovis tract homes, short-cycling usually traces to return-air starvation from collapsed flex duct in the attic or an oversized furnace for the floor plan. When return air is choked, the furnace overheats, trips the limit switch, and cycles off early. Then the house cools, the furnace restarts, and the cycle repeats. We measure static pressure to confirm it. Call (559) 354-6878 and we’ll diagnose the airflow, not just the parts.
Usually not. If your original furnace never heated the back bedrooms evenly, replacing it with the same tonnage recreates the same problem. The real issue is often undersized or damaged ductwork, not the furnace itself. We measure the duct system before recommending any replacement. That’s the difference between a parts swap and a repair that actually fixes your comfort.
Often yes. Clovis gets far more cooling load than heating load, so a heat pump handles both jobs efficiently. The catch is proper sizing: an undersized heat pump will struggle on the rare 30-degree night, and an oversized one will short-cycle in summer and kill its own compressor early. We do a load calculation on every replacement quote. Call for a free estimate and we’ll give you real numbers.
Clovis’s rapid eastward expansion has created a measurable urban heat island effect. Attics in newer tract neighborhoods stay hotter, longer, into the evening. That sustained heat bakes electrical components. Capacitors degrade faster, blower motor windings dry out, and control boards crack solder joints. A furnace that sits unused through a hot summer and then gets asked to start on a cold December morning is statistically more likely to fail on that first start. A $80 – $200 tune-up in October catches most of these failures before they strand you.
If your furnace is near end-of-life, a heat pump replacement often makes more sense than repairing the gas furnace and then adding a separate AC system later. You get heating and cooling in one unit, and you avoid spending repair money on a furnace you’ll replace anyway. But this depends on your duct condition and electrical panel. We’ll inspect both before making a recommendation. Call (559) 354-6878 and we’ll give you an honest answer with written pricing.
Call Brandt HVAC Co Fresno for Furnace Repair in Clovis
You’ll know the technician’s name before they knock. You’ll see their photo ID at the door. You’ll get a written price before any work starts, and a written guarantee on every repair. If it’s not done right, we come back free. That’s the standard Devin Marlowe runs this business on. Call (559) 354-6878 now. A live person answers, day or night.
Written by Devin Marlowe, Owner at Brandt HVAC Co Fresno, serving Clovis and the surrounding Central Valley. The name Brandt comes from an old word for a firebrand, fitting for the work of keeping a home warm.